Heart Necklace Kit Instructions

Heart Necklace Kit Instructions - Page 2

You're making great progress! Follow the steps below to finish your heart necklace. Almost there!

Not there yet? Go back to the previous steps.

Step 7 - Add the charms

After the last pearl add 2 spacers and the charms. Slide the open jump ring with the heart charm directly onto the wire. Then slide the open jump ring with the pearl charm hanger next to it.

The charms are now hanging next to each other in the middle of the necklace.

Step 8 - String the second set of beads

After the charms continue with the same pattern as at the beginning. Start with 2 spacer beads. Then thread 1 rice pearl followed by 2 spacer beads. Repeat this 5 times so both sides of the necklace look the same.

Step 9 - Cut the wire

Hold the necklace for a moment to check that all the beads are properly in place and the charms hang nicely in the middle. Then cut the wire with the wire cutters. Leave about 2 cm of wire at the end. Thread a crimp bead at the end of the wire.

Step 10 - Attach the wire to the second link chain

Take the link chain with the extension chain. Thread the remaining wire through the first link and fold the wire double just like at the beginning.

Thread a crimp bead over both wires and slide it as close as possible to the link. Squeeze the crimp bead firmly with the flat nose pliers. Cut off the excess wire as short as possible with the wire cutters.